All the RansNet hardware comes with Ethernet interfaces and each interface by default is in routing/Layer-3 mode. If you onboarded the device using default template, the ethernet interfaces will automatically appear on the setting.
Below is a list of common settings available for all interfaces:
enable or disable
ip address setting (mbox support multiple IP addresses per physical or logical interface, for both IPv4 and IPv6 addresses).
MAC address setting. It is possible to change the default MAC address of each interface. Only do this for a specific reason that you’re fully aware of.
MTU size
duplex and speed (physical interface only)
CONFIGURATION STEPS
access to mbox through console or CLI
identify the interface that you wish to configure
enter into interface configuration mode and change specific settings
please add "ip default-gateway x.x.x.x" if you're not using DHCP to get WAN IP.
SUMMARY STEPS (ETHERNET)
enableconfigureinterface ethnumberlink auto/full/half speed (10/100/1000)enable (no enable)mac address new_macip address ip_address/prefix (no ip address ip_address/prefix)mtu new_mtu_sizeCONFIGURATION EXAMPLES
mbox> enablembox#mbox# configurembox(config)# interface eth0mbox(config-if)# enablembox(config-if)# link full 1000 (default link auto)mbox(config-if)# mac address 00:0c:29:7d:f7:79 (change this if ISP require a specific MAC to connect)mbox(config-if)# ip address 203.128.19.100/28 remark "public IP for server 1"mbox(config-if)# ip address 203.128.19.101/28 remark "public IP for server 2"mbox(config-if)# mtu 1500 (optional)mbox(config-if)# exitmbox(config)# ip default-gateway 203.128.19.103mbox# show running-config !interface eth1link full 1000enablemac address 00:0c:29:7d:f7:79ip address 203.128.19.100/28 remark "public IP for server 1"ip address 203.128.19.101/28 remark "public IP for server 2"mtu 1300!ip default-gateway 203.128.19.103!